Method of painting

If the paint on the wall at home is uneven and uneven, it may be that the right method is not used when painting. Let's explain some correct painting methods, especially some small details.

Before painting, you must make preparations, take out the shielding film to cover and protect the furniture and other places that do not need painting, so as to prevent these facilities from getting dirty in the process of painting.

In the process of home decoration wall painting, it is generally necessary to brush putty twice. Then is the crucial color matching work. It is necessary to accurately calculate the wall area to be painted. If there are color requirements, strictly control the materials of various colors to make the color reach the best state. The primer shall be applied before painting on the wall. In order to prevent the anti moisture of the wall, the color of the finish paint can also be more uniform. The next step is the topcoat. There is a certain brushing sequence for the construction of the topcoat, which needs to be brushed correctly according to the steps. Start with the ceiling, then the line, and finally the wall. The wall shall be painted at least twice. 5-10% water can be added to the first coating to facilitate the wall to absorb the coating. Do not add water to supplement the absorbed coating for the second time. Note: there should be a certain time interval between the second painting and the first painting.

During the rolling coating construction, two roller brushes with different thickness shall be used for construction. The thick Roller Brush shall be used to evenly coat the paint on the wall, and then the thin roller brush shall be used to re brush the place where the thick roller has been brushed, so as to make the wall paint delicate and brush the required patterns. Pay attention to the following points during roll coating: 1 Do not adhere too much paint to the drum. 2. The rolling pressure shall be uniform, the speed shall be moderate, and the rolling shall be uniform in horizontal, vertical and oblique directions. After the roller is painted, it is also necessary to touch up the missing parts of the wall and corner with a brush, especially the joint position between the wall and corner line, wooden cabinet, partition, etc. and the corner of the wall. After the wall paint is dry, the wall needs to be polished with sandpaper to reduce the brush marks on the wall and make the wall more smooth. Note that the polishing force should be moderate. Finally, check whether the color of the wall meets the design requirements, whether the color of the painted surface is consistent, and whether there is missing painting, uneven paint, etc. In the whole construction process, pay attention to the times and sequence of painting. Only by doing these details can the paint be painted better.